|
|
|
|
|
||||||||
|
|
|
|
|
||||||||
|
|
|
|
|
|
|
|
|
|
|||
|
|
|
|
|
|
|
|
|||||
|
|
|
|
|||||||||
|
|
|
||||||||||
| Home Page > Numasizing > Try It |
|
Try Numasizing
To optimally size the components of your pneumatic circuit using Numasizing, simply fill in the form below, to the best of your knowledge. A Numatics representative will contact you within a few days with the optimal results based on your goals. If you require faster results and/or anticipate frequent use of Numasizing, learn more about our new Numasizing 4.0 software by clicking here. INSTRUCTIONS: Using your mouse, or the [TAB] key, select an entry box to the right of the heading and type in your information. Click (or use the [TAB] key) inside the next box and continue filling out the form. You MUST enter your e-mail address in order for this form to be sent. If you make a mistake you can return to any line / box and edit or re-enter the data. You can also use the [Clear Form] button at the bottom of this page to erase the entire form and start over. When you have completed the form, click on the [Submit] button at the bottom of this page to send us the form. Be sure to fill out the form completely. If the form is not filled in completely (with the following exception *) it cannot be processed. *The branch conductor and manifold section is required to be filled in only when two or more actuators are used per valve. Please e-mail any questions you may have concerning either Numasizing or this form to:  | |||||||||||||
